New jig for Flax kit

New jig for Flax kit

After 1000's of builds we have changed the jig to make it simpler to build at home with greater accuracy. Our community has given us feedback and we are excited to launch the new and improve home build jig.

Here are some of the new features,

  • Flatpacked simple assemble and more robust in transit.
  • High level of tolerances so keeping your parts aligned.
  • Two point fixing for dropouts allowing for perfect alignment between drive and non drive, making it impossible to misalign the rear wheel.
  • Ability to work on any table top so you won't need to purshase a base board

Video Tutorial below



  • Posted on by Ted

    So far so good. I had to just sand a bit off to fit the BB onto its jig, and to get the drop out fittings in.

  • Posted on by Steve

    Wasn’t to happy with the second rate jig I was sent if it weren’t for my ability to
    Adapt and overcome bad design I would not have been able to complete my bike so I don’t think I’ll be buying anything from you guys again

  • Posted on by Paul

    Hi team, thanks, great video. What about boost spacing on the dropout?

  • Posted on by Ted

    Fantastic improvement over the previous jig! Well done!

  • Posted on by Henry

    Having built a kit a few years ago, bikes still going strong but this would have made it easier! Nice job!

Leave a comment

All blog comments are checked prior to publishing
You have successfully subscribed!
This email has been registered